Goodboy Kayaks racks. 1 or 2 for canoe and ama?
instead of dropping huge dough on a 2nd rack, get some smaller foam blocks from REI for the ama.
#1 Wed, 05/03/2017 - 6:30am
Do you have a Huki by chance? My V1-R fits fine on the standard Goodboy rack with the stubby iakos.
Your idea sounds fine. My only comment is that I would be tempted to consider a slimmer system so you could somewhat stagger the heights to not take up so much crossbar width - two Goodboy racks side by side take a good bit of width. Maybe you can sort of stagger them since you would have a shorter bar on the ama Goodboy and the Vs could also be a lot shorter.
#3 Fri, 05/05/2017 - 6:49am
I have an Antares. I drove back over a hundred miles from the Blackburn Challenge averaging about 80 mph with Goodboy wa'a and ama racks, No problems. Nice not having to jam the ama inside the vehicle.
#6 Thu, 08/03/2017 - 2:43am
Just curious as to how your canoe is now transported with the ama rack: do you now transport it fully assembled (rigged) with the ama and na iako attached? Loading and unloading a fully rigged outrigger is very convenient, if you're transporting only one canoe.
#7 Thu, 08/03/2017 - 11:23am

I am going to purchase a Goodboy Kayak rack for my OC1 but am wondering if I should buy two. One for the canoe and one for the ama. The ama will not fit inside my jeep grand cherokee. The ama is 9' and the rack is 8'. Cliff at Goodboy has offered to cut off some of the V to make it a better fit and I suggested cutting the overall length to 4'. The distance between my roof bars is 3'. I would rather get a 2nd Goodboy than strap the ama to a padded bar. Any help?
Submitted by JA on